Pro Toolkit dynamic simulator
Continuous Conveyor Control Simulator
Run a repeating material-transfer loop with explicit Start and Stop control. A completed transfer counts the part and immediately begins the next one without stopping the conveyor.
Looping conveyor control lab
Start latches the conveyor on. Every completed part immediately wraps to the entry for the next transfer, and the conveyor keeps running until you press Stop.
Manual conveyor configuration
Live conveyor loop
Part position wraps at the exit. The motor command stays latched through every transfer.
Command, signal, and motion path
The selected reference and raw output drop to zero on Stop while modeled speed follows the configured ramp.
Cycle history
Model boundary
This is an ideal teaching model for a latched start/stop command, repeating part travel, a linear analog speed reference, and a simple acceleration ramp. It does not model drive tuning, torque, slip, coast time, mechanical accumulation, jam detection, safety circuits, or real PLC scheduling.
Continuous conveyor control simulator
Inspect the stopped conveyor, default speed channel, part position, and complete Start and Stop control layout.
Start and stop continuous looping transfers, tune the belt model, and compare 4-20 mA or 0-10 V reference values with PLC counts and actual speed.
- Continuous part-transfer loop
- Explicit Start and Stop cycle
- Selectable analog speed reference and live motion
This workspace requires Pro Toolkit. The standard Toolkit tier does not unlock it.
Entitlement store: unavailable. No saved presets, saved settings, or customer tool history are stored in V1.